Re: Re: Case For a recording tuba

[ Follow Ups ] [ Post Followup ] [ TubeNet BBS ] [ FAQ ]

Posted by R Bruce Meng on August 12, 1999 at 15:39:14:

In Reply to: Re: Case For a recording tuba posted by Jacob on August 12, 1999 at 13:46:59:

A few years ago I had a custom case built by a guy at HARRDROAD(AT)

It was made using the same material that the Anvil cases are made from -- quarter-inch ABS plastic covered plywood with extruded aluminum corners and edges, with recessed latches. They charge primarily by outside dimensions and could fill with structural foam so that you could cut the foam to exactly fit your horn.

My case (for a large keyboard) ran at about $400 complete. My next two best estimates were $850 and over $1000.

Follow Ups: