Re: Bow Guard Plate Replacement *HELP*


[ Follow Ups ] [ Post Followup ] [ TubeNet BBS ] [ FAQ ]

Posted by Jay Bertolet on March 07, 2000 at 17:24:57:

In Reply to: Bow Guard Plate Replacement *HELP* posted by Santos on March 07, 2000 at 16:35:53:

I had this same problem a few years back when I had my Rudy overhauled. I discussed it with the repairman and he suggested simply removing the guard plates and installing a larger half-wire in place of the smaller existing one. This eliminates the nice silvery look on a brass tuba but it isn't bad once you get used to it. It also eliminates the problem of the guard fitting loosely and/or buzzing. My experience with this procedure has been very positive. I don't find that I get more or less dents because the plates aren't there. You might try this and see what you think. Good luck!


Follow Ups: