Re: Re: Re: plastic rotor bearings for Mirafone tuba


[ Follow Ups ] [ Post Followup ] [ TubeNet BBS ] [ FAQ ]

Posted by mix-n-match on September 06, 2000 at 20:43:05:

In Reply to: Re: Re: plastic rotor bearings for Mirafone tuba posted by Tim Cary on September 06, 2000 at 16:01:03:

Consider using the neoprene for the out-bound bumper and cork for the return side. At least then you will replace only one side now and again. The bounce always seemed worse when the valve was released, sometimes causing a flutter of unclarity during fast slurred runs. Or maybe there is a new high-tech material that is better???


Follow Ups: