Re: Re: rotor repair


[ Follow Ups ] [ Post Followup ] [ TubeNet BBS ] [ FAQ ]

Posted by Dave on September 08, 2002 at 11:17:34:

In Reply to: Re: rotor repair posted by Chuck(G) on September 07, 2002 at 10:35:32:

The silver solder is hard, primarily because it is not lead-based. I will give it a try.

My main concern at this point is that the stem appears to be lead-soldered into the rotor (there is some lead inside the bore of the rotor, at about the place where if there was a
bore for the stem, it would hit the web of the rotor). Are valve rotors three-piece and
soldered?


Follow Ups: