Re: Re: Re: Re: Re: Re: Where can I get parts for this?


[ Follow Ups ] [ Post Followup ] [ TubeNet BBS ] [ FAQ ]

Posted by Rick Denney on February 13, 2004 at 16:59:25:

In Reply to: Re: Re: Re: Re: Re: Where can I get parts for this? posted by bloke on February 12, 2004 at 09:11:42:

If you run the threaded rod through 1/8" brass tubing, and tighten the two ball joints against it, you can then bend it as needed and it looks quite nice. That's a little more appropriate looking than heat-shrink tubing. But of course it doesn't work any better.

Rick "who is a form-follows-function kind of guy" Denney


Follow Ups: