Re: Re: Dent Eraser


[ Follow Ups ] [ Post Followup ] [ TubeNet BBS ] [ FAQ ]

Posted by Jim Akins on January 15, 2002 at 15:32:19:

In Reply to: Re: Dent Eraser posted by From Parts Unknown on January 15, 2002 at 14:29:55:

The kit consists of 4 different balls toleranced out to the millionth of an inch--and extremely high grade, and a magnetic unit with incredible power. These magnets ARE NOT available in typical catalogs as some have inferred. These are specially created for this kit. You will not recreate this kit with what you think are strong magnets. It just isn't that simple. Also, Electro-magnets are not the way to go---trust me-- I fully experimented that possibility.

The kit and tool are simple to use. You roll one of the balls in the kit into the horn(use the largest size to fit the area affected), locate the ball by rolling it to where the magnetic unit is on the outside of the horn. Then you hold the unit, which is padded, and slide the unit past the dented area. Repeat until the dent is gone. Make sure you only slide and don't rock the unit. That is it! Most average dents are removed in seconds! Jim Akins


Follow Ups: